Needle Valve: A needle valve is a type of valve with a small port and a threaded, needle-shaped plunger. It allows precise regulation of flow, although it is generally only capable of relatively low flow rates.

Valve: Valves are for starting or stopping flow, regulating or throttling flow, preventing back flow or relieving and regulating pressure in fluid or gaseous handling applications. Common valve types include: Ball, Butterfly, Check, Diaphragm, Gate, Globe, Knife Gate, Parallel Slide, Pinch, Piston, Plug, Sluice, etc.

Balancing Valve: A balancing valve controls water flow and balances heat and cooling distribution to different locations. The purpose of the valve is to enable us to supply the correct amount of heat and cooling to each part of the building.

Valve: Valves are for starting or stopping flow, regulating or throttling flow, preventing back flow or relieving and regulating pressure in fluid or gaseous handling applications. Common valve types include: Ball, Butterfly, Check, Diaphragm, Gate, Globe, Knife Gate, Parallel Slide, Pinch, Piston, Plug, Sluice, etc.

Ball Valve: A ball valve is a form of quarter-turn valve which uses a hollow, perforated and pivoting ball to control flow through it. It is open when the ball’s hole is in line with the flow and closed when it is pivoted 90-degrees by the valve handle. Ball Valve is a Shutoff type valve which is used to control the flow of Fluid (Liquid/Gas). The valve basically has ball inside it which is used to control the flow, the ball is attached with an external lever which opens/closes the passage for fluid to pass through the valve. Usually ball valves are used for sizes below 100MM, above that gate valves are used instead of ball valve. Ball valves comes in various type and in various MOC

A non-return valve is a simple mechanical device that is used to allow a medium pressure flow in any one direction. It helps the fluid to travel with a medium velocity in one direction and prohibits the reverse flow of the fluid caused by very high pressure. The non-return valves cause a very high-pressure drop which is a drawback for it. it also helps to prevent the upstream types of equipment that could get damaged by reverse flow such as water pumps. They are also known as check valves. The non-return valves are available in various types such as clapper type, swing type, spring-loaded, etc. they could be manually operated or also by automated actuation.

Bonnet Wheel Valve: The cover for the opening sin the body is the bonnet, and it is the second most important boundary of a pressure valve. Like valve bodies, bonnets are in many designs and models available. A bonnet acts as a cover on the valve body, is cast or forged of the same material as the body. It is commonly connected to the body by a threaded, bolted, or welded joint. During manufacture of the valve, the internal components, such as stem, disk etc., are put into the body and then the bonnet is attached to hold all parts together inside.